Journal of the Japan Society of Powder and Powder Metallurgy
Online ISSN : 1880-9014
Print ISSN : 0532-8799
ISSN-L : 0532-8799
Developmetn of Solid Lubricants Dispersed Bronze Bearing Material by P/M (Second Report)
Effects of V Addition on Sinter Densification of Cu-Sn Alloy Compacts
Kazuo KatoMichitaka MorikawaMichihiro TagamiShinji YamadaTohru Takeda
Author information
JOURNAL OPEN ACCESS

2003 Volume 50 Issue 12 Pages 1057-1061

Details
Abstract
In the previous paper, we reported the densification of the bronze matrix was promoted by the diffusion of Cr under solid state sintering at 1030 K. In the present work, effects of V addition on sintering properties and microstructures of the bronze matrix were investigated, and compared with Cr. Mixed powders were prepared from pulverized V powders and atomized 90Cu-10Sn powders, of which particle sizes were 106-150μm and 1-38μm respectively. Compacts pressed at 390 MPa were sintered at 670-1030 K for 0.3-180 ks in H2. V diffuses preferentially into the surface and grain boundary of the bronze powder. With increasing sintering time at 1030 K, pores of matrix decrease rapidly. This indicates that the densification of the bronze is promoted by the diffusion of V as same as the case of Cr. However, some pores are observed on the matrix and the grain size is bigger than the case of Cr after 180ks sintering at 1030 K. From these results, it is assumed the effects of densification by V addition is slightly smaller than Cr.
Content from these authors
© Japan Society of Powder and Powder Metallurgy

本論文はCC BY-NC-NDライセンスによって許諾されています.ライセンスの内容を知りたい方は,https://creativecommons.org/licenses/by-nc-nd/4.0/deed.jaでご確認ください.
https://creativecommons.org/licenses/by-nc-nd/4.0/deed.ja
Previous article Next article
feedback
Top